Insight into steam reforming of ethanol to produce hydrogen for fuel cells

• Tipo: Outra Publicação em Revista Científica Internacional
• Data: 2006

Autores

Vaidya, PD (Autor) Outra; Alírio Rodrigues (Autor) FEUP

Revista

Título: Chemical Engineering Journal

Vol. 117 Nº 1

Páginas: 39-49

ISSN: 1385-8947

Editora: Elsevier

Indexação

ISI Web of Knowledge - 369 Citações

Scopus - 361 Citações

Outras Informações

ID Authenticus: P-004-MQS

DOI: 10.1016/j.cej.2005.12.008

Abstract (EN): Ethanol can be prepared from agricultural residues and hence is a renewable resource. Its production is simple and cheap and hence steam reforming of ethanol to produce hydrogen for fuel cells is attractive. Process engineering aspects of ethanol steam reforming are discussed here. High temperatures, low pressures and high water-to-ethanol ratios in the feed favor hydrogen production. Ni, Co, Ni/Cu and noble metal (Pd, Pt, Rh)-supported catalysts are promising. Major concerns are fast catalyst coking and formation of by-products such as methane, diethyl ether and acetaldehyde. To overcome these problems, the process should be carried out in a two-layer fixed bed catalytic reactor: at first, ethanol should be dehydrogenated to acetaldehyde in presence of Cu-based catalyst at 573-673 K and then this stream should be passed over a bed containing a mixture of Ni-based catalyst and a chemisorbent at low temperatures around 723 K. The entire process of ethanol steam reforming coupled with selective CO2 removal by chemisorption will enable production of high-purity H, and hence is very promising.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 11