Fatigue behaviour of metallic components obtained by topology optimization for additive manufacturing

• Tipo: Artigo em Revista Científica Internacional
• Data: 2021

Autores

F. K. Fiorentin (Autor) Outra; B. Oliveira (Autor) Outra; J. C. R. Pereira (Autor) Outra; José António F. O. Correia (Autor) FEUP; Abílio M. P. de Jesus (Autor) FEUP; F. Berto (Autor) Outra

Revista

Título: Frattura ed Integrita Strutturale

Vol. 15

Páginas: 119-135

ISSN: 1971-8993

Editora: Gruppo Italiano Frattura

Indexação

ISI Web of Knowledge - 0 Citações

Scopus - 1 Citação

Outras Informações

ID Authenticus: P-00T-B07

DOI: 10.3221/igf-esis.55.09

Abstract (EN): The main goal of the present research is to propose an integrated methodology to address the fatigue performance of topology-optimized components, produced by additive manufacturing. The main steps of the component design will be presented, specially the methods and parameters applied to the topology optimization and the post-smoothing process. The SIMP method was applied in order to obtain a lighter component and a suitable stiffness for the desired application. In addition, since residual stresses are intrinsic to every metallic additive manufacturing process, the influence of those stresses will be also analysed. The Laser Powder Bed Fusion was numerically simulated aiming at evaluating the residual stresses the workpiece during the manufacturing process and to investigate how they could influence the fatigue behaviour of the optimized component. The effect of the built orientation of the workpiece on the residual stresses at some selected potential critical points are evaluated. The final design solution presented a stiffness/volume ratio nearly 6 times higher when compared to the initial geometry. By choosing the built orientation, it is possible impact favourably in the fatigue life of the component.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 17