Dry reforming of methane using Pd-based membrane reactors fabricated from different substrates

• Tipo: Artigo em Revista Científica Internacional
• Data: 2013

Autores

Garcia Garcia, FR (Autor) Outra; Soria, M. A. (Autor) FEUP; Mateos-Pedrero, C. (Autor) FEUP; Guerrero Ruiz, A (Autor) Outra; Rodriguez Ramos, I (Autor) Outra; Li, K (Autor) Outra

Revista

Título: Journal of Membrane Science

Vol. 435

Páginas: 218-225

ISSN: 0376-7388

Editora: Elsevier

Indexação

ISI Web of Knowledge - 23 Citações

ISI Web of Science

Scopus - 31 Citações

Outras Informações

ID Authenticus: P-00M-N8E

DOI: 10.1016/j.memsci.2013.02.029

Abstract (EN): In this study, performance and feasibility of a hollow fibre membrane reactor (HFMR), consisting of a packed catalyst bed around a Pd coated Al2O3 hollow fibre membrane, has been studied and compared with both conventional Pd based tubular membrane reactor (TMR) fabricated from a stainless steel substrate and traditional fixed-bed reactor (FBR). The ceramic based HFMR presents several advantages over MRs such as the deposition of ultra thin Pd membranes and the possibility to scale up the whole multifunctional process by module configuration. The results obtained at 450 degrees C during the methane dry reforming (MDR) reaction showed that, although CH4 conversion using the HFMR was almost the same as that of a catalytic TMR, the amount of Pd employed for the Pd layer deposition in the HFMR was fifteen times less than that in TMR. Moreover, the CH4 conversion using the HFMR was 72% higher than that in a traditional FBR and 34% higher than thermodynamic equilibrium. Also, a high purity COx-free H-2 production (10.5 ml/mg h) was achieved at 525 degrees C using a sweep gas of 100 ml/min in the lumen side of the HFMR.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 8