Low torque loss gears: austempered ductile iron versus carburized steel

• Tipo: Artigo em Revista Científica Internacional
• Data: 2011

Autores

Magalhaes, L (Autor) FEUP; Martins, R (Autor) FEUP; Seabra, J (Autor) FEUP; Goncalves, R (Autor) Outra

Revista

Título: Proceedings of the Institution of Mechanical Engineers, Part J: Journal of Engineering Tribology

Vol. 225 Nº 12

Páginas: 1209-1216

ISSN: 1350-6501

Editora: SAGE

Indexação

ISI Web of Knowledge - 2 Citações

Scopus - 3 Citações

Classificação Científica

FOS: Ciências da engenharia e tecnologias > Engenharia mecânica

Outras Informações

ID Authenticus: P-002-J38

DOI: 10.1177/1350650111415483

Abstract (EN): Low-loss power transmission gears operate at lower temperature than conventional ones because their teeth geometry is optimized to reduce friction. The main objective of this work is to compare the operating stabilization temperature and efficiency of low-loss austempered ductile iron (ADI) and carburized steel gears. Three different low-loss tooth geometries were adopted (types 311, 411 and 611, all produced using standard 20 degrees pressure angle tools) and corresponding steel and ADI gears were tested in a FZG machine. The results obtained showed that low-loss geometries had a significant influence on power loss, gears 611 generating lower power loss than gears 311. At low speeds (500 and 1000 rpm) and high torque ADI gears generated lower power loss than steel gears. However, at high speed and high torque (high input power and high stabilization temperature) steel gears had better efficiency.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 8