Enhancement of a solar photo-Fenton reaction with ferric-organic ligands for the treatment of acrylic-textile dyeing wastewater

• Tipo: Artigo em Revista Científica Internacional
• Data: 2015

Autores

Petrick A. Soares (Autor) FEUP; Mauro Batalha (Autor) FEUP; Selene M. A. Guelli U. Souza (Autor) FEUP; Rui A. R. Boaventura (Autor) FEUP; Vítor J. P. Vilar (Autor) FEUP

Revista

Título: Journal of Environmental Management

Vol. 152

Páginas: 120-131

ISSN: 0301-4797

Editora: Elsevier

Indexação

ISI Web of Knowledge - 46 Citações

ISI Web of Science

Scopus - 72 Citações

Classificação Científica

FOS: Ciências da engenharia e tecnologias > Engenharia do ambiente

CORDIS: Ciências Tecnológicas > Tecnologia > Tecnologia ambiental

Projetos Associados

LA 20 - PROJECTO ESTRATÉGICO - LA 20 - 2013-2014

Outras Informações

ID Authenticus: P-00A-428

DOI: 10.1016/j.jenvman.2015.01.032

Abstract (EN): Literature describes a kinetic mineralization profile for most of acrylic-textile dyeing wastewaters using a photo-Fenton reaction characterized by a slow degradation process and high reactants consumption. This work tries to elucidate that the slow decay on DOC concentration is associated with the formation of stable complexes between Fe3+ and textile auxiliary products, limiting the photoreduction of Fe3+. This work also evaluates the enhancement of a solar photo-Fenton reaction through the use of different ferric-organic ligands applied to the treatment of a simulated acrylic-textile dyeing wastewater, as a pre-oxidation step to enhance its biodegradability. The photo-Fenton reaction was negatively affected by two dyeing auxiliary products: i) Sera (R) Tard A-AS, a surfactant mainly composed of alkyl dimethyl benzyl ammonium chloride and ii) Sera (R) Sperse M-IW, a dispersing agent composed of polyglycol solvents. The catalytic activity of the organic ligands toward the ferrous-catalysed system followed this order: Fe(III)Oxalate > Fe(III)-Citrate > Fe(III)-EDDS, and all were better than the traditional photo-Fenton reaction. Different design parameters such as iron concentration, pH, temperature, flow conditions, UV irradiance and H2O2 addition strategy and dose were evaluated. The ferrioxalate induced photo-Fenton process presented the best results, achieving 87% mineralization after 9.3 kJ(UV) L-1 and allowing to work until near neutral pH values. As expected, the biodegradability of the textile wastewater was significantly enhanced during the photo-Fenton treatment, achieving a value of 73%, consuming 32.4 mM of H2O2 and 5.7 kJ(UV) L-1.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 12