Temperature and nitrogen-induced modification of activated carbons for efficient catalytic ozonation of salicylic acid as a model emerging pollutant

• Tipo: Artigo em Revista Científica Internacional
• Data: 2023

Autores

Graca, CAL (Autor) Outra; Zema, R (Autor) Outra; Orge, CA (Autor) Outra; Restivo, J (Autor) Outra; Sousa, J (Autor) Outra; Manuel Fernando R Pereira (Autor) FEUP; O.S.G.P. Soares (Autor) FEUP

Revista

Título: Journal of Environmental Management

Vol. 344

ISSN: 0301-4797

Editora: Elsevier

Indexação

ISI Web of Knowledge - 0 Citações

Scopus

Outras Informações

ID Authenticus: P-00Y-S0T

DOI: 10.1016/j.jenvman.2023.118639

Abstract (EN): The occurrence of emerging pollutants on effluents of wastewater treatment plants makes unfeasible their reutilization and consequently to comply with the sixth goal of 2030 Agenda for sustainable development. Thus, it is extremely important to find ways to remove these pollutants without compromising the quality of reclaimed water. Ozonation has been successfully explored for this purpose, but it still presents limitations towards some oxidant-resistant pollutants. To surpass this, the conversion of ozone (O3) into more reactive species is required, which can be accomplished by using catalysts. Carbon catalysts, such as activated carbons (ACs), represent a more environmentally attractive option than traditional metal-based catalysts, with the advantage of being easily modified to tune their textural and surface properties to the reaction chemistry. In this study, two different sources of ACs were tested in the catalytic ozonation of a frequently detected emerging pollutant: salicylic acid (SalAc). These ACs were submitted to thermal treatment under H2 and functionalization with N precursors, such as melamine and poly(ethyleneimine), to induce changes in the surface properties, especially in the nitrogen content. Although no correlation was found between the N-content and catalytic activity, the thermal treatment under H2 increased the mesopores surface area (Smeso), which reflected in greater catalytic activity. As that, the best-performing AC was the one with the highest Smeso, which revealed also to be resistant to O3 and able to convert O3 into more reactive species, evidenced by the capacity of oxalic acid, a well-known ozone-resistant byproduct. The same AC was then submitted to three consecutive reutilization cycles and a more significant activity loss was observed in terms of SalAc degradation rate (- 40%) then total organic carbon removal (- 25%), from the first to the third cycle. This decline in efficiency was ascribed to the presence of by-products adhered to the catalyst surface, which impede its ability to react effectively with O3.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 8