Quantifying the drilling effect during the application of incremental hole-drilling technique in laminate composites

• Tipo: Artigo em Livro de Atas de Conferência Internacional
• Data: 2011

Autores

J. P. Nobre (Autor) Outra; J.-H. Stiffel (Autor) Outra; W. Van Paepegem (Autor) Outra; A. Nau (Autor) Outra; A. C. Batista (Autor) Outra; M. J. Marques (Autor) FEUP; B. Scholtes (Autor) Outra

Ata de Conferência Internacional

Título: RESIDUAL STRESSES VIII

Páginas: 510-515

8th European Conference on Residual Stresses (ECRS 8)

Riva del Garda, ITALY, JUN 26-28, 2010

Indexação

ISI Proceedings

ISI Web of Knowledge - 4 Citações

Scopus - 9 Citações

Classificação Científica

CORDIS: Ciências Tecnológicas > Engenharia > Engenharia mecânica ; Ciências Tecnológicas > Engenharia > Engenharia de materiais

FOS: Ciências da engenharia e tecnologias > Engenharia mecânica

Outras Informações

ID Authenticus: P-002-WH6

DOI: 10.4028/www.scientific.net/msf.681.510

Abstract (EN): In this work, a methodology to quantify the effect of the drilling operation, during the application of the incremental hole-drilling technique (IHD) for measuring residual stresses in laminate composites, in particular, the polymer matrix composites (PMC), is presented. This technique will allow the optimization of the drilling procedures and its parameters, enabling the quantification of the drilling effect. This quantification is obtained by using an experimental calibration procedure followed by a numerical simulation of the whole process. The direct comparison of the experimental and numerical results will allow quantifying the effect of the drilling operation. As example, the methodology was applied to the case of carbon/epoxy cross-ply laminate [0 degrees/90 degrees](5s). The holes have been made by using two different drilling procedures, but the same tool geometry. High speed milling powered by air compression, a process usually employed in the case of the application of hole-drilling technique to metal alloys and a conventional computer numerically controlled (CNC) milling machine, were used. The results seem to show that incremental hole-drilling could be a reliable technique to determine residual stresses in fibre-reinforced polymers.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 6