Saltar para:
Logótipo
Você está em: Início > Publicações > Visualização > Thin-film composite forward osmosis membranes based on polysulfone supports blended with nanostructured carbon materials

Thin-film composite forward osmosis membranes based on polysulfone supports blended with nanostructured carbon materials

Título
Thin-film composite forward osmosis membranes based on polysulfone supports blended with nanostructured carbon materials
Tipo
Artigo em Revista Científica Internacional
Ano
2016
Autores
Sergio Morales Torres
(Autor)
FEUP
Carla M. P. Esteves
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
José L. Figueiredo
(Autor)
FEUP
Revista
Vol. 520
Páginas: 326-336
ISSN: 0376-7388
Editora: Elsevier
Outras Informações
ID Authenticus: P-00K-R1B
Abstract (EN): Polysulfone (PSf) membrane supports were blended with pristine multi-walled carbon nanotubes (MWCTNs), functionalized MWCNTs (MWf), graphene oxide (GO) and their corresponding carbon-TiO2 composites. The surface hydrophilicity and the porous structure of the supports depended markedly on loading, type and surface chemistry of the nanostructured material, as well as on the addition or not of polyvinylpyrrolidone (PVP). These PSf supports were used to develop polyamide thin-film composite (TFC) membranes, whose performance was evaluated in forward osmosis using distilled water and 0.6 M NaCl solutions. TFC membranes prepared on PSf supports containing MWf and GO showed higher water permeation and draw solute rejection than those with hydrophobic MWCNTs or neat PSf only. An improved performance was observed when both carbon-TiO2 composites and PVP were used, due to a porous structure of more elongated and straight finger-like pores and enhanced hydrophilicity. Among them, the most permeable membrane was that containing 0.5 wt% of a GO-TiO2 composite and PVP (9.6-12.5 L m(-2) h(-1) of water flux; ca. 43-60% higher than a TFC membrane on a commercial PSf support). However, the best performing membrane (8.4-20.3 L m(-2) h(-1) for 0.6-2.0 M NaCl, respectively) with the lowest specific solute flux (0.41-0.66 g L-1, respectively) was that obtained when replacing GO by MWf.
Idioma: Inglês
Tipo (Avaliação Docente): Científica
Nº de páginas: 11
Documentos
Não foi encontrado nenhum documento associado à publicação com acesso permitido.
Publicações Relacionadas

Da mesma revista

Zirconium oxide hybrid membranes for direct methanol fuel cells - Evaluation of transport properties (2006)
Artigo em Revista Científica Internacional
Silva, VS; Ruffmann, B; Silva, H; Silva, VB; Adélio Mendes; Luis Madeira; Nunes, S
Xenon recycling in an anaesthetic closed-system using carbon molecular sieve membranes (2007)
Artigo em Revista Científica Internacional
S. Lagorsse; Magalhaes, F. D; A. Mendes
The effects of Anodonta cygnea biological fluids on biomineralization of chitosan membranes (2010)
Artigo em Revista Científica Internacional
Anabela Lopes; Manuel Lopes Lima; Iulius Bobos; Jorge Ferreira; Silvia Gomes; Rui Reis; Joao Mano; Jorge Machado
Study and optimization of aroma recovery from beer by pervaporation (2009)
Artigo em Revista Científica Internacional
Margarida Catarino; António Ferreira; Adélio Mendes
Stable cellulose-based carbon molecular sieve membranes with very high selectivities (2022)
Artigo em Revista Científica Internacional
Tiago Araújo; Márcia Andrade; Gabriel Bernardo; Adélio Mendes

Ver todas (34)

Recomendar Página Voltar ao Topo
Copyright 1996-2024 © Faculdade de Engenharia da Universidade do Porto  I Termos e Condições  I Acessibilidade  I Índice A-Z  I Livro de Visitas
Página gerada em: 2024-10-01 às 06:43:38 | Política de Utilização Aceitável | Política de Proteção de Dados Pessoais | Denúncias