Evaluation of SICAN performance for biofouling mitigation in the food industry

• Tipo: Artigo em Revista Científica Internacional
• Data: 2016

Autores

J. M. R. Moreira (Autor) FEUP; R. Fulgêncio (Autor) FEUP; P. Alves (Autor) FEUP; I. Machado (Autor) FEUP; I. Bialuch (Autor) Outra; L. F. Melo (Autor) FEUP; M. Simões (Autor) FEUP; F. J. Mergulhão (Autor) FEUP

Revista

Título: Food Control

Vol. 62

Páginas: 201-207

ISSN: 0956-7135

Editora: Elsevier

Indexação

ISI Web of Knowledge - 5 Citações

ISI Web of Science

Scopus - 12 Citações

Classificação Científica

FOS: Ciências da engenharia e tecnologias

CORDIS: Ciências Tecnológicas

Projetos Associados

LEPAE/CEFT - RL2 - (Bio) Chemical Engineering: Multi-Scale Approaches for Sustainable Environment and Health

LEPABE - Laboratório de Engenharia de Processos, Ambiente, Biotecnologia e Energia

Outras Informações

ID Authenticus: P-00G-W43

DOI: 10.1016/j.foodcont.2015.10.023

Abstract (EN): Biological fouling in food industry leads to an increase in maintenance costs, decreases operational efficiencies and promotes food contamination leading to economic losses and the dissemination of foodborne pathogens. In order to maintain production efficiency and hygienic standards, cleaning in place (CIP) procedures are required. However, the existence of critical zones shielded from the main flow carrying the CIP disinfectants requires new strategies for reducing biofilm buildup and/or easy to clean surfaces. In this work, a Diamond-Like Carbon (DLC) coating modified by incorporation of silicon (a-C:H:Si or SICAN), was evaluated regarding bacterial adhesion, biofilm formation and cleanability. Assays included the natural flora present in industrial water (from a salad washing line) and Escherichia coli, one of the most persistent foodborne microorganisms. Results show that bacterial adhesion and biofilm formation on SICAN and stainless steel were similar, thus surface modification was not able to prevent biological fouling development. However, it was verified that after performing a cleaning protocol with chlorine, reduction of bacterial counts was much higher in SICAN (about 3.3 Log reduction) when compared to stainless steel (1.7 Log reduction). Although full biofilm recovery was observed on both surfaces 18 h after treatment, an operational window was identified for which processes with cleaning intervals of about 6 h could potentially use SICAN surfaces on critical areas (such as dead zones, crevices, corners, joints) and therefore operate at a much higher hygienic level than the one attained with stainless steel.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 7