Carbon nanotubes as catalysts for wet peroxide oxidation: The effect of surface chemistry

• Tipo: Artigo em Revista Científica Internacional
• Data: 2019

Autores

Maria Martin-Martinez (Autor) Outra; Bruno F. Machado (Autor) FEUP; Philippe Serp (Autor) Outra; Sergio Morales-Torres (Autor) Outra; Adrián M.T. Silva (Autor) Outra; José L. Figueiredo (Autor) Outra; Joaquim L. Faria (Autor) Outra; Helder T. Gomes (Autor) Outra

Revista

Título: Catalysis Today

Vol. 165

Páginas: 1-9

ISSN: 0920-5861

Editora: Elsevier

Indexação

ISI Web of Knowledge - 3 Citações

ISI Web of Science

Scopus - 5 Citações

Projetos Associados

IF/00301/2015 - Projeto de investigação exploratória

Outras Informações

ID Authenticus: P-00Q-9JY

DOI: 10.1016/j.cattod.2019.03.014

Abstract (EN): Three magnetic carbon nanotube (CNT) samples, named A30 (N-doped), E30 (undoped) and E10A20 (selectively N-doped), synthesized by catalytic chemical vapor deposition, were modified by introducing oxygenated surface groups (oxidation with HNO 3 , samples CNT-N), and by heat treatment at 800 °C for the removal of surface functionalities (samples CNT-HT). Both treatments lead to higher specific surface areas. The acid treatment results in more acidic surfaces, with higher amounts of oxygenated species being introduced on N-doped surfaces. Heat-treated samples are less hydrophilic than those treated with nitric acid, heat treatment leading to neutral or basic surfaces, only N-quaternary and N-pyridinic species being found by XPS on N-doped surfaces. These materials were tested in the catalytic wet peroxide oxidation (CWPO) of highly concentrated 4-nitrophenol solutions (4-NP, 5 g L ¿1 ) at atmospheric pressure, T = 50 °C and pH = 3, using a catalyst load of 2.5 g L ¿1 and the stoichiometric amount of H 2 O 2 needed for the complete mineralization of 4-NP. The high temperature treatment enhanced significantly the activity of the CNTs towards CWPO, evaluated in terms of 4-NP and total organic carbon conversion, due to the increased hydrophobicity of their surface. In particular, E30HT and E10A20HT were able to remove ca. 100% of 4-NP after 8 h of operation. On the other hand, by treating the CNTs with HNO 3 , the activity of the less hydrophilic samples decreased upon increasing the concentration of surface oxygen-containing functionalities, whilst the reactivity generated inside the opened nanotubes improved the activity of the highly hydrophilic A30 N. © 2019 Elsevier B.V.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 9