A study on milling of glass fiber reinforced plastics manufactured by hand-lay up using statistical analysis (ANOVA)

• Tipo: Artigo em Revista Científica Internacional
• Data: 2004

Autores

João Paulo Davim (Autor) Outra; Pedro Reis (Autor) Outra; Carlos Conceição António (Autor) FEUP

Revista

Título: Composite Structures

Vol. 64 Nº 3

Páginas: 493-500

ISSN: 0263-8223

Editora: Elsevier

Indexação

ISI Web of Knowledge - 108 Citações

Scopus - 130 Citações

Outras Informações

ID Authenticus: P-000-A1T

DOI: 10.1016/j.compstruct.2003.09.054

Abstract (EN): Milling is the most practical machining (corrective) operation for removing excess material to produce a well defined and high quality surface. However, milling composite materials presents a number of problems such as surface delamination associated with the characteristics of the material and the cutting parameters used. In order to minimize these problem is presented a study with the objective of evaluating the cutting parameters (cutting velocity and feed rate) related to machining force in the workpiece, delamination factor, surface roughness and international dimensional precision in two GFRP composite materials (Viapal VUP 9731 and ATLAC 382-05). A plan of experiments, based on an orthogonal array, was established considering milling with prefixed cutting parameters. Finally an analysis of variance (ANOVA) was preformed to investigate the cutting characteristics of GFRP composite materials using a cemented carbide (K10) end mill.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 8