Saltar para:
Logótipo
Você está em: Início > Publicações > Visualização > Nano-Displacement Measurement Using an Optical Drop-Shaped Structure

Nano-Displacement Measurement Using an Optical Drop-Shaped Structure

Título
Nano-Displacement Measurement Using an Optical Drop-Shaped Structure
Tipo
Artigo em Revista Científica Internacional
Ano
2021
Autores
Paulo Robalinho
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Ver página do Authenticus Sem ORCID
Orlando Frazão
(Autor)
FEUP
Ver página pessoal Sem permissões para visualizar e-mail institucional Pesquisar Publicações do Participante Ver página do Authenticus Sem ORCID
Revista
Vol. 33 2
Páginas: 65-68
ISSN: 1041-1135
Editora: IEEE
Indexação
Publicação em ISI Web of Knowledge ISI Web of Knowledge - 0 Citações
Publicação em Scopus Scopus - 0 Citações
Outras Informações
ID Authenticus: P-00T-6X8
Abstract (EN): This letter presents a new optical fiber structure with the capability of measuring nano-displacement. This device is composed by a cleaved fiber and a drop-shaped microstructure that is connected to the fiber cladding. This optical structure is responsible for the light beam division and the formation of new optical paths. The operation mode consists of the Vernier effect that allows achieving higher sensitivity than the currently sensors. During the experimental execution, displacement sensitivities of 1.05 +/- 0.01 nm , 15.1 +/- 0.1 nm, 24.7 +/- 0.3 nm and 28.3 +/- 0.3 nm , were achieved for the carrier, the fundamental of the envelope, the first harmonic and the second harmonic, respectively. The M-factor of 27 was attained, allowing a minimum resolution of 0.7 nm. In addition to displacement sensing, the proposed optical sensor can be used as a cantilever enabling non-evasive measurements.
Idioma: Inglês
Tipo (Avaliação Docente): Científica
Nº de páginas: 4
Documentos
Não foi encontrado nenhum documento associado à publicação.
Publicações Relacionadas

Dos mesmos autores

Giant Displacement Sensitivity Using Push-Pull Method in Interferometry (2021)
Artigo em Revista Científica Internacional
Paulo Robalinho; Orlando Frazão
Colossal Enhancement of Strain Sensitivity Using the Push-Pull Deformation Method (2021)
Artigo em Revista Científica Internacional
Paulo Robalinho; André Gomes; Orlando Frazão

Da mesma revista

Temperature-Monitored Fibre Optic Current Sensor Using Channelled-Spectrum Analysis (2022)
Artigo em Revista Científica Internacional
Robalinho, P; Melo, M; Frazao, O; Ribeiro, ABL
Temperature-Independent Multi-Parameter Measurement Based on a Tapered Bragg Fiber (2016)
Artigo em Revista Científica Internacional
Martins, TJM; marques, mb; Roy, P; Jamier, R; Fevrier, S; Frazao, O
Temperature-Independent Curvature Sensor Using FBG Cladding Modes Based on a Core Misaligned Splice (2011)
Artigo em Revista Científica Internacional
Gouveia, C; Jorge, PAS; Baptista, JM; Frazao, O
Temperature Compensated Strain Sensor Based on Long-Period Gratings and Microspheres (2018)
Artigo em Revista Científica Internacional
Ascorbe, J; Coelho, L; Santos, JL; Frazao, O; Corres, JM
Temperature and Strain Sensing With Femtosecond Laser Written Bragg Gratings in Defect and Nondefect Suspended-Silica-Core Fibers (2012)
Artigo em Revista Científica Internacional
Luis Andre Fernandes; Martin Becker; Orlando Frazao; Kay Schuster; Jens Kobelke; Manfred Rothhardt; Hartmut Bartelt; Jose Luis Santos; Paulo V S Marques

Ver todas (49)

Recomendar Página Voltar ao Topo
Copyright 1996-2025 © Faculdade de Medicina Dentária da Universidade do Porto  I Termos e Condições  I Acessibilidade  I Índice A-Z
Página gerada em: 2025-11-03 às 00:13:58 | Política de Privacidade | Política de Proteção de Dados Pessoais | Denúncias | Livro Amarelo Eletrónico