Saltar para:
Logótipo
Você está em: Início > Publicações > Visualização > Catalytic conversion of cellulose to sorbitol over Ru supported on biomass-derived carbon-based materials

Catalytic conversion of cellulose to sorbitol over Ru supported on biomass-derived carbon-based materials

Título
Catalytic conversion of cellulose to sorbitol over Ru supported on biomass-derived carbon-based materials
Tipo
Artigo em Revista Científica Internacional
Ano
2019
Autores
Natalia Rey-Raap
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
José Melo Orfão
(Autor)
FEUP
José Luis Figueiredo
(Autor)
FEUP
Manuel Fernando R. Pereira
(Autor)
FEUP
Revista
Vol. 256
ISSN: 0926-3373
Editora: Elsevier
Outras Informações
ID Authenticus: P-00Q-RA7
Abstract (EN): The direct conversion of cellulose into sorbitol, one of the platform molecules of highest potential, by using a low-cost catalyst that yields higher productivity is a current challenge. Ruthenium/glucose-derived carbons with tailored textural and chemical properties were prepared by combining two different strategies: activation and addition of carbon nanotubes (CNT) to obtain a hybrid carbon material (AG-CNT). The appropriate combination of both strategies results in materials with high microporosity and low acidity that favors the dispersion of the metal and, hence, improves the yield of sorbitol. The total conversion of cellulose (100%) and the highest yield of sorbitol (64.1%) were achieved over a hybrid catalyst with high specific surface area of 1200 m(2) g(-1) (Ru/AG-CNT1200) within 3 h of reaction, at 205 degrees C and 50 bar of H-2. In addition, the catalyst was successfully recycled in four runs. These results are better than those reported over Ru/CNT (the highest yield reported to date over carbon supports) under the same reaction conditions, indicating that CNT can be successfully replaced by a low-cost support derived from biomass. As a result, not only the highest yield of sorbitol is obtained, but cellulose, one of the most important fractions of biomass, is valorized through two pathways: the cellulose itself as the main raw material of the reaction and its monomer, glucose, for the preparation of the catalyst.
Idioma: Inglês
Tipo (Avaliação Docente): Científica
Nº de páginas: 13
Documentos
Não foi encontrado nenhum documento associado à publicação.
Publicações Relacionadas

Dos mesmos autores

Glucose-based carbon materials as supports for the efficient catalytic transformation of cellulose directly to ethylene glycol (2019)
Artigo em Revista Científica Internacional
Lucília Sousa Ribeiro; Natalia Rey-Raap; José Luis Figueiredo; José Melo Orfão; Manuel Fernando R. Pereira

Da mesma revista

Heterogeneous photo-Fenton oxidation with pillared clay-based catalysts for wastewater treatment: A review (2010)
Outra Publicação em Revista Científica Internacional
J. Herney - Ramírez; Miguel A. Vicente; Luis M . Madeira
Electrochemical advanced oxidation processes: A review on their application to synthetic and real wastewaters (2017)
Outra Publicação em Revista Científica Internacional
Vitor Vilar; Maria Francisca Moreira; Rui Boaventura; Francisca Moreira
Catalytic wet air oxidation of low molecular weight carboxylic acids using a carbon supported platinum catalyst (2000)
Outra Publicação em Revista Científica Internacional
Gomes, HT; Figueiredo, JL; Faria, JL
Catalysts for methanol steam reforming-A review (2010)
Outra Publicação em Revista Científica Internacional
Sandra Sá; Hugo Silva; Lúcia Brandão; José M. Sousa; Adélio Mendes

Ver todas (129)

Recomendar Página Voltar ao Topo
Copyright 1996-2025 © Faculdade de Medicina Dentária da Universidade do Porto  I Termos e Condições  I Acessibilidade  I Índice A-Z
Página gerada em: 2025-09-15 às 23:16:36 | Política de Privacidade | Política de Proteção de Dados Pessoais | Denúncias | Livro Amarelo Eletrónico