Corrosion behaviour of commercially pure titanium shot blasted with different materials and sizes of shot particles for dental implant applications

• Tipo: Artigo em Revista Científica Internacional
• Data: 2003

Autores

Conrado Aparicio (Autor) Outra; F. Javier Gila (Autor) Outra; Carlos Fonseca (Autor) FEUP; Mário Adolfo Barbosa (Autor) FEUP; Josep Anton Planell (Autor) Outra

Revista

Título: Biomaterials

Vol. 24 Nº 2

Páginas: 263-273

ISSN: 0142-9612

Editora: Elsevier

Indexação

ISI Web of Knowledge - 226 Citações

Scopus - 247 Citações

Outras Informações

ID Authenticus: P-000-J8C

DOI: 10.1016/s0142-9612(02)00314-9

Abstract (EN): It is well known that the osseointegration of the commercially pure titanium (c.p. Ti) dental implant is improved when the metal is shot blasted in order to increase its surface roughness. This roughness is colonised by bone, which improves implant fixation. However, shot blasting also changes the chemical composition of the implant surface because some shot particles remain adhered on the metal. The c.p. Ti surfaces shot blasted with different materials and sizes of shot particles were tested in order to determine their topographical features (surface roughness, real surface area and the percentage of surface covered by the adhered shot particles) and electrochemical behaviour (open circuit potential, electrochemical impedance spectroscopy and cyclic polarisation). The results demonstrate that the increased surface area of the material because of the increasing surface roughness is not the only cause for differences found in the electrochemical behaviour and corrosion resistance of the blasted c.p. Ti. Among other possible causes, those differences may be attributed to the compressive residual surface stresses induced by shot blasting. All the materials tested have an adequate corrosion and electrochemical behaviour in terms of its possible use as dental implant material.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 11