Saltar para:
Logótipo
Você está em: Início > Publicações > Visualização > Interferometric optical fiber inclinometer with dynamic FBG based interrogation

Interferometric optical fiber inclinometer with dynamic FBG based interrogation

Título
Interferometric optical fiber inclinometer with dynamic FBG based interrogation
Tipo
Artigo em Livro de Atas de Conferência Internacional
Ano
2011
Autores
da Silveira, CR
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Carvalho, JP
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Jorge, PAS
(Autor)
FCUP
Costa, JWA
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Giraldi, MTR
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Santos, JL
(Autor)
FCUP
Carvalho Junior, EL
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Figueredo, DO
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Frazao, O
(Autor)
FCUP
Ver página pessoal Sem permissões para visualizar e-mail institucional Pesquisar Publicações do Participante Ver página do Authenticus Sem ORCID
Ata de Conferência Internacional
International Conference on Applications of Optics and Photonics
Braga, Portugal, 3 a 7 de Maio de 2011
Classificação Científica
FOS: Ciências da engenharia e tecnologias > Engenharia electrotécnica, electrónica e informática
Outras Informações
ID Authenticus: P-005-5MR
Abstract (EN): The development of an interferometric optical fiber inclinometer is described in this paper. A weak tapered region is induced in a standard single mode fiber in the vicinity of the cleaved fiber tip, using a standard fusion splicer. In this situation an in-fiber Michelson interferometer is constructed that is sensitive to curvature applied in the tapered region. It is shown that depending on the angular range, fringe visibility and/or peak position depend strongly on the applied curvature enabling low cost dielectric inclinometer to be setup that is suitable for high voltage applications. It is presented an analysis of the sensor response by means of experimental measurements and manipulation of these experimental data through computational simulations. The results coming from the numerical simulations indicate a good performance of the sensor within range of angular variation between 3 and 6 degrees and 10 and 14 degrees. A low cost strategy to interrogate the response of sensor using electrically modulated fiber Bragg gratings, a photodetector and frequency analysis is described. The results presented by this electric interrogation technique show a good sensitivity in the range 3.5 to 5.5 degrees.
Idioma: Inglês
Tipo (Avaliação Docente): Científica
Documentos
Não foi encontrado nenhum documento associado à publicação.
Recomendar Página Voltar ao Topo
Copyright 1996-2025 © Faculdade de Medicina Dentária da Universidade do Porto  I Termos e Condições  I Acessibilidade  I Índice A-Z
Página gerada em: 2025-09-03 às 13:24:44 | Política de Privacidade | Política de Proteção de Dados Pessoais | Denúncias | Livro Amarelo Eletrónico