Saltar para:
Logótipo
Comuta visibilidade da coluna esquerda
Você está em: Início > Publicações > Visualização > The Influence of Pre-Incubation Treatment in the In Vitro Biological Performance of Degradable CaO-P2O5 Glass Ceramics

Publicações

The Influence of Pre-Incubation Treatment in the In Vitro Biological Performance of Degradable CaO-P2O5 Glass Ceramics

Título
The Influence of Pre-Incubation Treatment in the In Vitro Biological Performance of Degradable CaO-P2O5 Glass Ceramics
Tipo
Artigo em Revista Científica Internacional
Ano
2005
Autores
Dias, A
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Lopes, MA
(Autor)
FEUP
Santos, JD
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Fernandes, MHF
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Revista
Vol. 13
Páginas: 565-568
ISSN: 1013-9826
Outras Informações
ID Authenticus: P-00T-AT3
Abstract (EN): <jats:p>Based upon the CaO-P2O5 glass system, two glass ceramics were prepared in the meta-, pyro- and orthophosphate regions. The present work describes results concerning the biological activity of MT13B (45CaO-37P2O5-5MgO-13TiO2, in mol %) and MK5B (45CaO-45P2O5-5MgO-5K2O, in mol %) using MG63 osteoblast-like cells cultured for 6 days. The influence of a 24h pretreatment with culture medium before cell culture was also evaluated (MT13Bi; MK5Bi). Both ¿as received¿ and pre-treated material samples supported cell growth, which increased with the culture time. Pre-treatment resulted in an increase of adhered cells on both materials (day 1). Throughout the culture time (days 3 and 6), MT13Bi presented higher cell numbers than that of MT13B, but no differences were found between MK5Bi and MK5B. In addition, cell growth was significantly lower in the K-containing glass ceramic in both experimental situations comparing with Ticontaining glass ceramic. SEM and confocal microscopy observation showed that cell adhesion and spreading were hampered on MK5B samples. Evident macroscopic and microscopic surface instability was observed on this material with simultaneous dissolution/precipitation processes. By contrast, MT13B presented a relatively stable surface throughout the culture time. Results suggest that the pre-incubation with culture medium improves the adhesion of the osteoblast cells to both glass ceramics and that the high degradation rate of MK5B hinders the in vitro biological performance of this material.</jats:p>
Idioma: Inglês
Tipo (Avaliação Docente): Científica
Documentos
Não foi encontrado nenhum documento associado à publicação.
Publicações Relacionadas

Da mesma revista

Key Engineering Materials: Preface (2011)
Outra Publicação em Revista Científica Internacional
Ochsner, A; Da Silva, LFM; Altenbach, H
Zr bearing gamma-TiAl induction melted (2000)
Artigo em Revista Científica Internacional
J. Barbosa; A. Duarte; Carlos Silva Ribeiro; Filomena Viana; C. Monteiro
Zirconium bearing g-TiAl induction melted (2000)
Artigo em Revista Científica Internacional
J. Barbosa; António Paulo Duarte; Carlos Silva Ribeiro; Filomena Viana
Three Dimensional Macroporous Calcium Phosphates Scaffolds for Bone Tissue Engineering (2008)
Artigo em Revista Científica Internacional
S. Teixeira; S. Oliveira; M. P. Ferraz; F. J. Monteiro
Thermo-mechanical processing of a Ti 49.5Al 1.25Ag alloy (2001)
Artigo em Revista Científica Internacional
António Paulo Duarte; Filomena Maria da Conceição Viana; Manuel Fernando Gonçalves Vieira; Henrique Manuel Cunha Martins dos Santos

Ver todas (58)

Recomendar Página Voltar ao Topo
Copyright 1996-2025 © Faculdade de Direito da Universidade do Porto  I Termos e Condições  I Acessibilidade  I Índice A-Z
Página gerada em: 2025-09-25 às 17:08:49 | Política de Privacidade | Política de Proteção de Dados Pessoais | Denúncias | Livro Amarelo Eletrónico