Saltar para:
Logótipo
Comuta visibilidade da coluna esquerda
Você está em: Início > Publicações > Visualização > The role of loading mode on the property degradation of adhesives at high temperatures

Publicações

The role of loading mode on the property degradation of adhesives at high temperatures

Título
The role of loading mode on the property degradation of adhesives at high temperatures
Tipo
Artigo em Revista Científica Internacional
Ano
2023
Autores
Lopes, FVBD
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Akhavan-Safar, A
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Ricardo Carbas
(Autor)
FEUP
Marques, EAS
(Autor)
FEUP
Ver página pessoal Sem permissões para visualizar e-mail institucional Pesquisar Publicações do Participante Ver página do Authenticus Sem ORCID
Goyal, R
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Jennings, J
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
da Silva, LFM
(Autor)
Outra
A pessoa não pertence à instituição. A pessoa não pertence à instituição. A pessoa não pertence à instituição. Sem AUTHENTICUS Sem ORCID
Revista
Vol. 46
Páginas: 1848-1863
ISSN: 8756-758X
Editora: Wiley-Blackwell
Indexação
Publicação em ISI Web of Knowledge ISI Web of Knowledge - 0 Citações
Outras Informações
ID Authenticus: P-00X-YSD
Abstract (EN): Despite existing studies on the effects of temperature on the behavior of bonded joints, the role of loading mode and test type (strength, fatigue, and fracture tests) on the rate of degradation of adhesive/joint properties at high temperatures has not been adequately investigated. The aim of the current study is to determine if adhesives experience the same rate of degradation at high temperature when they are subjected to different mode mixities. To do so, an epoxy adhesive was subjected to strength, fracture, and S-N fatigue tests, for modes I and II, at different temperatures. The results show that there is a significant difference between the rate of degradation in mode I/tensile and mode II/shear loading conditions. It was also found that the rate of degradation in adhesive properties is a function of test type. Based on the results, by increasing the temperature, a less reduction in tensile strength was found in the Arcan joints (almost 50% reduction) compared with the dogbone specimen (where the strength was reduced by less than 40%). According to the results, for all the considered tests, temperature sensitivity was more noticeable in tensile loading conditions compared with the shear mode. It is shown that despite the reduction in tensile fracture energy with temperature (by around 23%), the shear fracture energy was improved (by over 20%) at 50 degrees C. Based on these results, an S-N model was also developed to create a master S-N curve, plotted as a function of temperature.
Idioma: Inglês
Tipo (Avaliação Docente): Científica
Nº de páginas: 16
Documentos
Não foi encontrado nenhum documento associado à publicação.
Publicações Relacionadas

Da mesma revista

Guest editorial: Special issue-New trends in fatigue and fracture (NT2F18) (2019)
Outra Publicação em Revista Científica Internacional
Luís Reis; Manuel de Freitas; Paulo Tavares de Castro
Guest editorial: Advanced design and fatigue assessment of structural components (2019)
Outra Publicação em Revista Científica Internacional
Correia, JAFO; Berto, F; Ayatollahi, M; Marsavina, L; Kotousov, A; Sedmak, A
Current fatigue and fracture research in Portugal (2004)
Outra Publicação em Revista Científica Internacional
Paulo Tavares de Castro
Validation of procedures for fatigue life assessment of a steel pressure vessel (2004)
Artigo em Revista Científica Internacional
Abílio Pinho de Jesus; A. S. Ribeiro; António Fernandes
The residual stress intensity factors for cold-worked cracked holes: a technical note (2004)
Artigo em Revista Científica Internacional
Pedro M. G. P. Moreira; P. F. P. de Matos; S. T. Pinho; S. D. Pastrama; Pedro Camanho; Paulo Tavares de Castro

Ver todas (25)

Recomendar Página Voltar ao Topo
Copyright 1996-2025 © Faculdade de Direito da Universidade do Porto  I Termos e Condições  I Acessibilidade  I Índice A-Z
Página gerada em: 2025-09-07 às 00:32:58 | Política de Privacidade | Política de Proteção de Dados Pessoais | Denúncias