Machinability study on polyetheretherketone (PEEK) unreinforced and reinforced (GF30) for applications in structural components

• Tipo: Artigo em Revista Científica Internacional
• Data: 2003

Autores

João Paulo Davim (Autor) Outra; Pedro Reis (Autor) Outra; Vítor Lapa (Autor) Outra; Carlos Conceiçãoi António (Autor) FEUP

Revista

Título: Composite Structures

Vol. 62 Nº 1

Páginas: 67-73

ISSN: 0263-8223

Editora: Elsevier

Indexação

ISI Web of Knowledge - 86 Citações

Scopus - 94 Citações

Outras Informações

ID Authenticus: P-000-EX5

DOI: 10.1016/s0263-8223(03)00085-0

Abstract (EN): Composites such as polyetheretherketone (PEEK) used in structural components, are generally manufactured by extrusion, and for this fact, these recent materials need additional machining operations. One of the major concerns in machining is to reach a good surface roughness and dimensional precision. So the aim of this paper is the study of the cutting parameters (cutting velocity and feed rate) under machining force (F-m), specific cutting pressure (K-s), surface roughness (R-a) and International dimensional precision (IT) in PEEK unreinforced and reinforced (GF30). A plan of experiments, based on the methodology of Taguchi, was established considering turning with prefixed cutting parameters in the PEEK workpiece. The analysis of variance was preformed to investigate the cutting characteristics of PEEK using a polycrystalline diamond cutting tool.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 7