Influence of the Glidant on Diluent Flow Characterization Using Shear Cell Method

• Tipo: Artigo em Revista Científica Internacional
• Data: 2020

Autores

Salustio, PJ (Autor) Outra; Machado, M (Autor) Outra; Nunes, T (Autor) Outra; Paulo Silva (Autor) FFUP; Paulo Costa (Autor) FFUP

Revista

Título: Journal of Pharmaceutical Innovation

ISSN: 1872-5120

Editora: Springer Nature

Indexação

ISI Web of Knowledge - 1 Citação

Scopus - 1 Citação

Outras Informações

ID Authenticus: P-00S-RK3

DOI: 10.1007/s12247-020-09478-6

Abstract (EN): Purpose The aim of this study was to compare the bulk lactose flow behavior with a defined fraction with smaller particles obtained by sieving from the bulk lactose and to evaluate the effect of a glidant addition on both samples. These powders showed, in a previous work, similar flow indexes (ff(c)) that motivated the addition of colloidal silicon dioxide in order to observe if there were any changes in their flow behaviors. Methods To evaluate this effect on the diluent flow behavior, the methods described in the European Pharmacopeia were used. Results The results obtained from conventional methods and shear cell methods (using the Powder Flow Tester) were compared, and they showed evident differences in the bulk and tapped densities values and flow classifications. The lactose monohydrate (F-Total) and lactose with particles smaller than 63 mu m (F < 63) analyzed in a previous study presented similarff(c). To these pure powders a glidant was added, in increasing proportion (0.25-1.00%). The results obtained for all powders with colloidal silicon dioxide showed an improvement in its flow behaviors in comparison with pure powders. Conclusion All the parameters studied showed an evident effect of the glidant used. For the same amount of glidant, the F < 63 presented worse flow profiles than F(Total)because its particles have a larger surface area. The F-Total + 0.25 flow profile was more similar to the F < 63 + 0.50 flow profile than F < 63 + 0.25 flow profile. For both powders, the maximum amount of glidant that produces effect was 1.00% for F < 63 and 0.75% for F-Total, respectively. In all powders, the occurrence of caking was not observed.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 11