Cold rolled versus sputtered Ni/Ti multilayers for reaction-assisted diffusion bonding

• Tipo: Artigo em Revista Científica Internacional
• Data: 2016

Autores

Emadinia, O (Autor) Outra; Simões, S (Autor) FEUP; Filomena Viana (Autor) FEUP; Vieira, MF (Autor) FEUP; Cavaleiro, AJ (Autor) Outra; Ramos, AS (Autor) Outra; Vieira, MT (Autor) Outra

Revista

Título: Welding in the World, Le Soudage Dans Le Monde

Vol. 60

Páginas: 337-344

ISSN: 0043-2288

Editora: Springer Nature

Indexação

ISI Web of Knowledge - 15 Citações

Scopus - 16 Citações

Outras Informações

ID Authenticus: P-00K-04T

DOI: 10.1007/s40194-015-0282-8

Abstract (EN): Reaction-assisted diffusion bonding of TiNi to Ti6Al4V was carried out using two types of filler materials: (i) Ni/Ti multilayer foils produced by accumulative roll bonding (ARB) and (ii) Ni/Ti multilayer thin films prepared by magnetron sputtering. In ARB, nanostructures were produced through severe plastic deformation by stacking alternated Ni and Ti foils and rolling at a strain rate of 20 s(-1) up to 16 cycles, attaining a total thickness close to 300 mu m. Using ARB Ni/Ti ultrafine multilayers, it was possible to achieve sound joints at undemanding conditions for a solid-state joining process (800 degrees C/10 MPa/60 min), with a shear strength of 35 MPa. The layered structure of the foil transforms into TiNi with small regions of Ti2Ni and TiNi3; a continuous layer of Ti2Ni is observed close to the Ti6Al4V base material. Ni/Ti multi-layer thin films with nanometric modulation periods have also been successfully used to produce sound joints at 750 and 800 degrees C, under 10 or 50 MPa during 60 min, with a shear strength of 88 MPa. The interface is very thin (less than 10 mu m) and exhibits several zones; comprising a Ti2Ni layer close to the Ti6Al4V alloy, followed by TiNi and Ti2Ni phases.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 8