Deep-beams with indirect supports: numerical modelling and experimental assessment

• Tipo: Artigo em Revista Científica Internacional
• Data: 2008

Autores

Mario Pimentel (Autor) FEUP; Paulo Cachim (Autor) Outra; Joaquim Figueiras (Autor) FEUP

Revista

Título: Computers and Concrete

Vol. 5 Nº 2

Páginas: 117-134

ISSN: 1598-8198

Editora: Techno Press

Indexação

ISI Web of Knowledge - 8 Citações

Scopus - 8 Citações

Classificação Científica

FOS: Ciências da engenharia e tecnologias > Engenharia civil

Outras Informações

ID Authenticus: P-004-0B9

DOI: 10.12989/cac.2008.5.2.117

Abstract (EN): An experimental and numerical research was conducted to gain a deeper insight on the structural behaviour of deep-beams with indirect supports and to assess the size effects in the ultimate state behaviour. The experimental campaign focused on the influence of the reinforcement tie distribution height on the compression check of the support region and on the benefits of using unbonded prestressing steel. Three reduced scale specimens were tested and used to validate the results obtained with a nonlinear finite element model. As a good agreement could be found between the numerical and the experimental results, the numerical model was then further used to perform simulations in large scale deep-beams, with dimensions similar to the ones to be adopted in a practical case. Two sources of size effects were identified from the simulation results. Both sources are related to the concrete quasi-brittle behaviour and are responsible for increasing failure brittleness with increasing structural size. While in the laboratory models failure occurred both in the experimental tests as well as in the numerical simulations after reinforcement yielding, the numerically analysed large scale models exhibited shear failures with reinforcement still operating in the elastic range.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 18