Sensing and control of segmented mirrors with a pyramid wavefront sensor in the presence of spiders

• Tipo: Artigo em Livro de Atas de Conferência Internacional
• Data: 2017

Autores

Schwartz N. (Autor) Outra; Sauvage J.F. (Autor) Outra; Correia C. (Autor) Outra; Petit C. (Autor) Outra; Quiros-Pacheco F. (Autor) Outra; Fusco T. (Autor) Outra; Dohlen K. (Autor) Outra; El Hadi K. (Autor) Outra; Thatte N. (Autor) Outra; Clarke F. (Autor) Outra; Paufique J. (Autor) Outra; Vernet J. (Autor) Outra

Ata de Conferência Internacional

Título: Adaptive Optics for Extremely Large Telescopes, 2017 AO4ELT5

Indexação

Scopus - 10 Citações

Outras Informações

ID Authenticus: P-014-ZD4

Abstract (EN): The secondary mirror unit of the European Extremely Large Telescope (ELT) is supported by six 50-cm wide spiders, providing the necessary stiffness to the structure while minimising the obstruction of the beam. The deformable quaternary mirror (M4) contains over 5000 actuators on a nearly hexagonal pattern. The reflective surface of M4 itself is composed of a segmented thin shell made of 6 discontinuous petals. This segmentation of the telescope pupil will create areas of phase isolated by the width of the spiders on the wavefront sensor (WFS) detector, breaking the spatial continuity of the wavefront data. The poor sensitivity of the Pyramid WFS (PWFS) to differential piston (or of any WFS sensitive to the derivative of the wavefront such as the Shack-Hartmann) will lead to badly seen and therefore uncontrollable differential pistons between these areas. In close loop operation, differential pistons between segments will settle around integer values of the average sensing wavelength lambda. The differential pistons typically range from one to tens of time the sensing wavelength and vary rapidly over time, leading to extremely poor performance. In addition, aberrations created by atmospheric turbulence will naturally contain some differential piston between the segments. This differential piston is typically a relatively large multiple of the sensing wavelength, especially for 40 m class telescopes. Trying to directly remove the entire piston contribution over each of the DM segments will undoubtedly lead to poor performance. In an attempt to reduce the impact of unwanted differential pistons that are injected by the AO correction, we compare three different approaches. A first step is to try to limit ourselves to use only the information measured by the PWFS, in particular by reducing the modulation. We show that using this information sensibly is important but it is only a prerequisite and will not be sufficient. We discuss possible ways of improvement by removing the unwanted differential pistons from the DM commands while still trying to maintain the atmospheric segment-piston contribution by using prior information. A second approach is based on phase closure of the DM commands and assumes the continuity of the correction wavefront over the entire unsegmented pupil. The last approach is based on the pair-wise slaving of edge actuators and shows the best results. We compare the performance of these methods using realistic end-to-end simulations. We find that pair-wise slaving leads to a small increase of the total wavefront error, only adding between 20-45 nm RMS in quadrature for seeing conditions between 0.45"-0.85". Finally, we discuss the possibility of combining the different proposed solutions to increase robustness.

Idioma: Inglês

Tipo (Avaliação Docente): Científica