Selective Laser Sintering (SLS) tool for Electrical Discharge Machining (EDM)

• Tipo: Artigo em Livro de Atas de Conferência Nacional
• Data: 2002

Autores

José Duarte Marafona (Autor) FEUP; Laura Martins (Autor) FEUP; Ricardo Nuno Pinto Pacheco (Autor) Outra; Paulo Miguel Aguiar Pinto (Autor) Outra

Ata de Conferência Nacional

Título: rpd2002-advanced solutions and development

rpd2002-advanced solutions and development

Marinha Grande, 8 e 9 October 2002

Outras Informações

Abstract (EN): Electrical Discharge Machining (EDM) is widely used in the production of dies. The paper describes an investigation into the manufacturing of EDM electrodes which are obtained using Selective Laser Sintering (SLS) and electroplating which led to a decrease of the time production. This work has led to the usage of two production techniques: the indirect and direct approaches. The EDM performance evaluation of the tools was carried out using Taguchi method. The evaluation of the collected data shows a significant improvement on TWR.

Idioma: Português

Tipo (Avaliação Docente): Científica

Nº de páginas: 3