Drilling of carbon fibre reinforced laminates : a study

• Tipo: Artigo em Livro de Atas de Conferência Internacional
• Data: 2009

Autores

Luís M. P. Durão (Autor) Outra; Daniel J. S. Gonçalves (Autor) FEUP; João Manuel R. S. Tavares (Autor) FEUP; Victor H. C. Albuquerque (Autor) Outra; A. Torres Marques (Autor) FEUP; A. M. Baptista (Autor) FEUP

Ata de Conferência Internacional

Título: V International Materials Symposium MATERIAIS 2009

Páginas: 1-6

V International Materials Symposium MATERIAIS 2009 (XIV meeting of SPM - Sociedade Portuguesa de Materiais)

Instituto Superior Técnico, Lisbon, Portugal, 5-8 April 2009

Classificação Científica

FOS: Ciências da engenharia e tecnologias > Engenharia mecânica

CORDIS: Ciências Tecnológicas > Engenharia > Engenharia mecânica

Outras Informações

Abstract (EN): The distinguishing characteristics of carbon fibre reinforced laminates, like low weight, high strength or stiffness, had resulted in an increase of their use during the last decades. Although parts are normally produced to ¿near-net¿ shape, machining operations like drilling are still needed. In result of composites non-homogeneity, this operation can lead to delamination, considered the most serious kind of damage as it can reduce the load carrying capacity of the joint. A proper choice of tool and cutting parameters can reduce delamination substantially. In this work the results obtained with five different tool geometries are compared. Conclusions show that the choice of adequate drill geometry can reduce thrust forces, thus delamination damage.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 6