Water Diffusion in Double Cantilever Beam Adhesive Joints

• Tipo: Artigo em Revista Científica Internacional
• Data: 2017

Autores

Viana, G (Autor) Outra; Costa, M (Autor) Outra; Banea, MD (Autor) Outra; da Silva, LFM (Autor) FEUP

Revista

Título: Latin American Journal of Solids and Structures

Vol. 14

Páginas: 188-201

ISSN: 1679-7817

Editora: Argentinean Association of Computational Mechanics

Indexação

ISI Web of Knowledge - 1 Citação

Scopus - 16 Citações

Outras Informações

ID Authenticus: P-00M-R9W

DOI: 10.1590/1679-78253040

Abstract (EN): Structural adhesives are increasingly being used in the aerospace and automotive industries. They allow for light weight vehicles, fuel savings and reduced emissions. However, the environmental degradation of adhesive joints is a major setback in its wide implementation. Moisture degradation of adhesive joints includes plasticization, attacking of the interface, swelling of the adhesive and consequent creation of residual stresses. This may lead to reversible and irreversible damage. In this work double cantilever beam (DCB) specimens using two different adhesives for the automotive industry were subjected to two different ageing environments. They were tested periodically until the toughness of the adhesives stabilized, which means that they were fully degraded. An association was made between the toughness of the adhesive and the amount of water that it had absorbed. This way it was possible to indirectly measure the water uptake in an adhesive joint taking into account the water uptake properties of the adhesives studied, which had been determined in another study. It was found that diffusion of water into the studied adhesive joints was faster than diffusion through the bulk adhesive alone. A model that takes into account diffusion through the interface between the adhesive and the adherends was proposed.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 14