Measurement of the hygric resistance of concrete blocks with perfect contact interface: influence of the contact area

• Tipo: Artigo em Revista Científica Internacional
• Data: 2021

Autores

António C. Azevedo (Autor) FEUP; João M. P. Q. Delgado (Autor) FEUP; Klayne Silva (Autor) Outra; André Leal (Autor) Outra; Ana Sofia Guimarães (Autor) FEUP; Isabel Martins Ribeiro (Autor) FEUP

Revista

Título: Open Civil Engineering Journal

Vol. 15 Nº 1

Páginas: 29-37

ISSN: 1874-1495

Editora: Bentham Science

Indexação

Scopus - 0 Citações

Outras Informações

ID Authenticus: P-00T-PXN

DOI: 10.2174/1874149502115010029

Abstract (EN): Introduction: Concrete sealing blocks are not only used in Brazil but worldwide. T he knowledge of the material properties in the presence of moisture becomes necessary to study the durability of buildings. Methods: An experimental study was carried out in order to analyse the effect of contact area on the capillary absorption coefficient of concrete samples used in sealing blocks, according to several standards: NBR 9779 (2012), EN 1015-18 (2002), ISO 15148 (2002) and ASTM C1794 (2015). Two types of specimens were analysed; monolithic samples and samples with a perfect contact interface. The monolithic samples were also subjected to axial and radial compression in order to enhance the capacity of masonry. Results: The experimental results for the samples with perfect contact interface indicate that the water absorption before the interface presents similar behaviour to the monolithic samples. However, it is possible to observe a reduction of the absorption rate when water reaches the interface due to the hygric resistance. In other words, the moisture transport is significantly retarded by the existence of an interface, i.e., the discontinuity of moisture content across the interface indicated that there was a difference in capillary pressure across the interface. Also, the interface contact area does not greatly influence the water-resistance values. Conclusion: Finally, the Hygric Resistance values (HR), in multilayer building components, with perfect contact interface are calculated using the ¿knee point¿ methodology. © 2021 Azevedo et al.

Idioma: Inglês

Tipo (Avaliação Docente): Científica

Nº de páginas: 9