Characterizing fracture forming limit and shear fracture forming limit for sheet metals

• Type: Article in International Scientific Journal
• Date: 2018

Authors

José Ferreira Duarte (Author) FEUP; Ana Reis (Author) FEUP; kishore Jawale (Author) Other; M. B. Silva (Author) Other

Journal

Title: Journal of Materials Processing Technology

Vol. 255

Pages: 886-897

ISSN: 0924-0136

Publisher: Elsevier

Indexing

ISI Web of Knowledge - 4 Citations

Scopus - 15 Citations

Other information

Authenticus ID: P-00N-K5N

DOI: 10.1016/j.jmatprotec.2018.01.035

Abstract (EN): This article investigates, experimentally, the failure loci in transition region between failure by crack-opening by mode I and by mode II of fracture mechanics. This investigation determines the fracture forming limit (FFL) and the shear fracture forming limit (SFFL) for copper with 0.8 mm and brass with 1 mm of thickness, by means of conventional sheet metal tests. Special focus is given to the use of staggered C-slit shear tests in order to obtain fracture strain pairs in the transition zone between FFL and SFFL, and the obtained results are presented. The procedure makes use of circle-grid analysis, thickness measurements and digital image correlation system (DIC). The fracture loci for the copper sheet were validated by simple and complex geometries deformed by single point incremental forming (SPIF). These different geometries allowed to obtain different strain paths (plane strain, shear and bi-axial deformation) with and without fracture, and revealed a good agreement between the results.

Language: English

Type (Professor's evaluation): Scientific

No. of pages: 12