Evaluation of the rotation capacity limits of steel members defined in EC8-3

• Type: Article in International Scientific Journal
• Date: 2017

Authors

Araujo, M (Author) Other; Macedo, L (Author) Other; J. M. Castro (Author) FEUP

Journal

Title: Journal of Constructional Steel Research

Vol. 135

Pages: 11-29

ISSN: 0143-974X

Publisher: Elsevier

Indexing

ISI Web of Knowledge - 21 Citations

Scopus - 24 Citations

Other information

Authenticus ID: P-00M-PHR

DOI: 10.1016/j.jcsr.2017.04.004

Abstract (EN): One issue of major importance regarding the application of seismic assessment guidelines is that of the deformation capacity limits prescribed for the various limit states. In the case of existing steel structures, Part 3 of Eurocode 8 (EC8-3) defines the limits in terms of plastic rotations, which are only applicable to cases where normalized axial load levels are lower than 0.3 and to cross-section classes of type 1 and 2. These limits resemble the ones defined in ASCE 41, suggesting a direct reproduction from the latter document despite their derivation on the basis of typical American profiles. Hence; this paper aims at evaluating the deformation capacity of European steel members and to answer the question of how adequate are the current EC8-3 limits. Based on detailed FE models, the influence of member imperfections, axial load and real ground motion records is assessed. Fracture due to ultra-low cycle fatigue is taken into account and general expressions for predicting the rotation capacity of a wide number of European cross-section profiles are proposed.

Language: English

Type (Professor's evaluation): Scientific

No. of pages: 19